Electric Linear Slides EAS Series
EASM4YE040ARMC
Product Classification | Product Name | List Price | Shipping Date |
---|---|---|---|
Actuator | EASM4YE040ARMC | Rs. 61,200 | 30 Working Days (Dispatch) |
• Driver: Select the driver that best describes your needs from the [Driver Introduction].
• The motor cable and electromagnetic brake cable from the motor cannot be connected directly to the driver. When connecting to the driver, use a connection cable.
Included
- Actuator: None
Specifications
Dimensions
Data Download
Other Specifications
Calculating Load Moment
When a load is transported with an electric linear slide or electric cylinder (a unit equipped with shaft guide covers only), the load moment acts on the linear guide/shaft guide if the position of the load's center of gravity is offset from the center of the table/center of the shaft guide. The direction of action applies to the directions for pitching (MP), yawing (MY), and rolling (MR), depending on the position of the offset.

Even though the selected electric actuators satisfy the load mass and positioning time requirements, when the center of gravity of the load is overhung from the table's center/shaft guide’s center, the run life may decrease as a result of the load moment. Load moment calculations must be completed and whether the conditions are within specifications values must be checked. The moment applied under static conditions is the static permissible moment. The moment applied under movement is the dynamic permissible moment, and both must be checked.
Calculate the load moment of the electric linear slides and electric cylinders (units equipped with shaft guide covers only) based on loads that are applied. Check that the static permissible moment and dynamic permissible moment are within limits and check that strength is sufficient.

- *For more information on calculating static permissible moment and dynamic permissible moments, click here.
Load Moment Formula
When there are several overhung loads, etc., it is determined by the sum of moments from all loads.
For Multiple Loads (n)
Travel Direction
At the time of shipment, the travel direction of the table is set as follows.

Standards
Regulations and Standards Materials
Documents about compliance with regulations and standards can be downloaded from the "Data Download" tab on the product details page.
(The types of files available for download vary by product.)
Explanations of the Global Laws, Regulations and Standards can be found here.
Information about our compliance with regulations and standards for each of our product series can be found here.
Hazardous Substances
The product does not contain any substances (10 substances) exceeding the regulation values of the RoHS Directive (2011/65/EU, 2015/863/EU).
Driver Introduction
You can choose from the following drivers. Click here for details on driver features and product lines
Driver Type | Features | Product Name | |||
---|---|---|---|---|---|
Built-in Controller Type ![]() |
Features |
With this type, operation data is set in the driver, then selected and executed from the host system.
|
Product Name |
Single-Phase 100-120 VAC Single-Phase/Three-Phase 200-240 VAC |
|
Driver Type |
Pulse Input Type ![]() |
Features |
Operation is executed according to the pulse signal input to the driver.
|
Product Name |
Single-Phase 100-115 VAC Single-Phase 200-230 VAC Three-Phase 200-230 VAC |
Cables and Accessories

